Position-Electronics 5+3 Crane and Remote-Head
Description
The THOMA-Position-Electronics is a measuring and analyzing circuit for 3crane axes and 5 Remote-head channels.
The 32 Bit Microprocessor delivers a delay of 1ms betqween data-capturing and data output
Effect of parameters for the interface-protocol by dialogue between host and electronics:
- address of delay-times
- Assotiation of data-bloc to camera-number
- Adjustment of Baud-Rates (9600 bis 115200)
- Adjustment of blocfrequencies (50, 60, 100, 120Hz)
- Deinition of number of axes
If a time-code-generator is plugged to the RS 232 interface, a time-code for each data-bloc can be provided.
Technical Specification
Baudrate: 38.4 kBaud, 8 Bit, 1 Starbit, 1 Stopbit, keine Parität
Blockfrequency: 100Hz bei 50Hz Sync-Eingang 120Hz bei 60Hz Sync-eingang
Data-bloc: 27 Byte gesamt, 1 Starbyte, 1 Blockbyte, 8x3 Achsenbytes, 1 Checksummenbyte Synchronization: FBAS/NTSC-Eingang, keine Datenausgabe ohne Sync-Signal
Zeroing: Power on or Reset
RS 232: D-SUB 9-polig
Pin2: TX
Pin3: Rx
Pin5: Gnd
RS 485: D-SUB 9-pol
Pin2: Receive low
Pin3: Transmit low
Pin6: Gnd
Pin7: Receive high
Pin8: Transmit high
Power-connector: XLR-socket 4-pin
Voltage: 12Volt
Current: 800mA
Pin1: 0Volt
Pin4: 12Volt
Sensor-inputs: 3 x pin-socket , 6-pol
Input 1 bis 3: 24 Bit length
Pin 3: 0Volt, output
Pin 4: Inkrement A
Pin 5: Inkrement B
Pin 6: +5Volt, output
Sensor-inputs: Female jack, 12-pol
Pin A: 0Volt, output
Pin B: +5 volt, output
Pin C: PAN, Inkrement A, 24Bit
Pin D: PAN, Inkrement B, 24Bit
Pin E: TILT, Inkrement A, 24Bit
Pin F: TILT, Inkrement B, 24Bit
Pin G: ZOOM, Inkrement A, 24Bit
Pin H: ZOOM, Inkrement B, 24Bit
Pin J: FOCUS, Inkrement A, 24Bit
Pin K: Focus, Inkrement B, 24Bit
Pin K: free, Inkrement A, 24Bit
Pin M: free, Inkrement B, 24Bit
Sync-input: BNC-Buchse, 75 Ohm
Dimension: 150x150x50mm
Accessories: Atachment frame
Optional: Power-supply , 230Volt; 115Volt